How To Remove A Bathroom Vanity (Update 2021)

Removing a bathroom vanity is a necessary step before installing a new vanity, sink, and faucet. Learn how to remove a bathroom vanity. Read our blog to learn the right way. You can install a new bathroom vanity as part of the project if you are going to renovate the bathroom. Otherwise, your existing vanity is a lot of old vanity countertops that have become annoying or dull, probably not fitting well with your updated decor scheme.

Moreover, it is a relatively simple DIY home improvement project to install a bathroom vanity. If you are thinking of keeping your old one, this is the only reason to save money. Since fortunately, bathroom vanities are not so expensive, So they should be considered or replacement.

Before jumping into this dirty work, there are a few things you should keep in mind to protect the rest of your bathroom from debris and dust.

• Remove all your bathroom supplies from your vanity, open shelf, or sink.
• Call any light fixtures, fans, and vents that are not being replaced or removed with a cloth tarp.
• If there is any towel from the towel door or rack, remove it.
• Remove any bath mats, trash cans, rugs, or scales to keep the floor clean.
• Pull the cloth tops over your shower or bathtub. Let’s get started

How To Remove A Bathroom Vanity

Step 1: Cabinet ready

Removing drawers is a common-sense step that will make it easy to forget if your bathroom vanity isn’t too big but you shouldn’t forget to clean the vanity cabinet in a hurry. Also, remove your doors so that it gives you more space to work inside the cabinet.

Step 2: Disconnect the pop-up stopper

Now notice the vertical pipe coming down from the drain. Look at this drain tailpiece and the back, you can find the lever that is controlling your pop-up stopper. This lever presses it to disconnect it from the perforated piece of metal and moves it towards the end of the lever which is attached to the stopper lift rod, holding the metal clamp on the lever and this is also called clavis. There is no need to remove the tail stop from the lift rod and the stopper lever from the cleavage.

Step 3: Remove the drain P-trap

Look at the curved pipe attached to the end of the P-trap tailpiece. Then you can do this with your hands if you loosen the nut by pressing the mouth of the trap near the tail. But slide the trap down and you will need a tongue and grooved player to remove it. Loosen the nut at the other end of the trap then attach it to the drainage groove in the wall. Care should be taken as the trap is full of water and pulls towards you to release it. Leave the space empty or throw the water out in a bucket.

Note: If You Want To Learn More About How To Clean Kitchen Sink?, Read Here

Step 4: Disconnect the call

Close the water supply shut-off valve to relieve pressure on the water supply lines or before opening the faucet. Loosen the compression nuts on the shut-off valve with an adjustable wrench or player and remove the water supply lines. Then if you want now you can also remove the water supply lines from the faucet at this point, and you can even remove the bathroom sink and faucet, but it’s good to remember that these tasks are easier to do after removing the top.

Step 5: Cut the cooling near the vanity top and cabinet

Use a sharp utility knife to cut and seal up to the cabinet wall and countertop backsplash. note: If you are going to minimize the drywall repair after removing the bathroom vanity, you must do it carefully.

Step 6: Remove the vanity top

The top will be in the cabinet with the screws and you will probably need to reach the drawer hole with some screwdrivers. If you can’t find any kind of fastener or screw, the top is probably covered with some other sealant or stuck in the cabinet and it can be sticky even if there are screws.

Using a hammer, break the sealant bond by tapping the putty knife between the cabinet frame and the countertop. When your work around the cabinet is done then remove it with a helper using a piece bar to see the top of the top. Place it face down in the cabinet with the faucet hanging at the end so you can dip and remove the faucet and turn it over if you haven’t already.

Step 7: Unscrew the vanity and remove it

Identify all the screws that hold the cabinet to the wall and use a screwdriver and drill bit to pull them back. Once you have freed up all your vanity cabinet you can get someone to help you remove it from the wall. Find the beans at any level on the floor and then assume the work is done.

Note: If You Want To Learn More About How To Remove Tile From Concrete Floor?, Read Here

FAQ, s: How to remove a bathroom vanity

How much does it cost to replace a bathroom vanity?

As long as you have the tools at hand for the project, vanity removal in this DIY bathroom should be cost-free. The part that will spend for you can replace your pride in a new place. However, according to HomeAdvisor.com, you may have to spend 350 to ৪ 4000 to install a new bathroom vanity depending on what style of vanity you are deciding.

What to do with bathroom vanity after removal

If you want to use the vanity elsewhere, you can always set it aside and transport it while you are ready. Or if you plan to throw it away or keep it in storage, you may want to disassemble it first, but sticking it together can be challenging.

You can test the glue on the vanity if you want, remove the screws that hold the front of your vanity from one side and see if the joint separates from itself. If this is the case, disassembling the bathroom vanity into parts of its components will make it easier for you to dispose of your vehicle and save your storage space. Again if you find that the joints are sticky you don’t want to save the vanity, in this case, you can always spray it with a mallet after removing all the screws.

vanity damp: When you take any of your old pride to the dump, ask how to dispose of it properly. Isn’t that so? But if it’s not made of wood, they’ll probably instruct you to keep it on the ground without a pile of recycled wood. If you want to recycle it, it’s best to combine the vanity and sell it. Alternatively, you can call and donate all – to a charity such as Humanity Restaurant Outlet Residence.

Conclusion: How to remove a bathroom vanity

Your arrogance to the wall is just a matter of a handful of mounting screws and removing it will make it harder for you to remove the backsplash. Moreover, now you can remove your pride without tearing down the wall if you want. However, you have to be patient when removing any screws/glue that can secure your cabinet to the wall.

Hopefully, this blog post has been useful in figuring out how to remove a bathroom vanity. Happy Cleaning!

IF YOU LIKED THIS POST, CHECK OUT THESE SIMILAR TOPICS:
How To Clean Kitchen Cabinets | Wooden And Laminate
How To Paint Kitchen Cabinets Without Sanding In 2021